The clients started complaining about the firewall blocking some sites they need access to, double checked and Meraki wasnt configured to block those sites. You’re all set with a static IP on your Meraki MX!Ĭontact Pilot Support for more assistance, or check out the Support Center to see how to configure static IPs for other router types. ago I actually recently had something similar happen at a couple of different client sites. Step 5: Set the Address, Netmask, Gateway and DNS servers values - changes are automatically saved.

Step 4: Under “Uplink configuration” change the “IP assignment” to “Static” for the port you’re looking to change: Step 3: Choose “Configure” from the top ribbon Step 2: Open a web browser and visit: (no internet access needed to reach it) - also known as the “local status page” Step 1: Connect your computer/machine to the management port on your MX If you find yourself in that situation, follow the steps below to configure your Meraki MX’s WAN port with a static IP. Depending on your network setup or your ISP’s requirements though, a dynamic IP assignment might not be available and you need to have those IP addresses configured statically. With the MR series, outbound traffic refers to client traffic originating from the wireless network that is destined for the wired LAN or Internet. The Router Firewall Plus is an advanced router and firewall combo, bringing you enterprise-grade security, VPN for remote work and high network performance all in one. Last updated Save as PDF Table of contents Example Configurations Additional Resources Layer 3 Firewall rules provide an administrator granular access control of outbound client traffic. By default, all Cisco Meraki MX appliances have their WAN interfaces configured to automatically receive an IP address via DHCP from your upstream provider/ISP. Meraki Go (powered by Cisco) is an easy-to-install, secure Wi-Fi solution for small businesses.

Meraki firewall